無線LANアクセスポイントの設置場所や設置台数を検討する際に給電方法について検討する必要がある。給電方法の選択肢は二つの選択肢から選ぶ。どちらの選択肢であってもコストに影響するため見積もり漏れが発生しないようにする。
純正の電源アダプタから給電する
PoEインジェクタやPoEスイッチから給電する
執務エリアなどの机上に置くケースで電源アダプタを選択することもあるが、PoEにて給電することがほとんど。PoEの規格は2021年3月の段階で以下の三種類存在する。
まとめ:
設置する無線LANアクセスポイントの必要とする電力に満たない場合、性能が劣化するか正常に起動しない
設置済みのPoEスイッチやPoEインジェクタを流用する際は、規格や給電容量に注意する
Wi-Fi6は広帯域であるためマルチギガビットイーサネットに対応したポートへ収容することも考慮する(要求仕様次第でネットワーク機器構成そのものの見直しの可能性も考慮する)
PoEスイッチで複数台の無線LANアクセスポイントへ給電する際は、PoEスイッチの給電容量を超えないように注意する
PoEスイッチやPoEインジェクタは、無線LANアクセスポイントの追加や接続先変更を考慮した配置にする
UTPケーブルはケーブルの抵抗が低いCategory5e以上を(給電という切り口で)推奨する
※帯域面では規格にマッチしたカテゴリかつ適切な長さのケーブルを使用すること